Please help, the following how to connect with Ginkgo usb-can bus adapter! Figure for the white USB interface! Can I connect directly to the CAN adapter from the USB port?
For CAN bus connection, detail please refer our docs where could be downloaded from: http://www.viewtool.com/index.ph ... 28-ginkgo-usb-can-3
Usually doing this way:
Ginkgo interface H: connect to other CAN device H;
Ginkgo interface L: connect to other CAN device L;
If need 120ohm internal resistance, please connect R with L;
If required GND connect to other CAN device GND, then do GND connection. Normally it's not required.
Post on 2017-12-21 09:02:32
Post on 2019-5-7 07:09:31